FOLAI 4-in-1 Metal AC Stud Detector Wall Wire Scanner Wood Finder with LCD Display in Pakistan for Rs. 4199.00

FOLAI 4-in-1 Metal AC Stud Detector Wall Wire Scanner Wood Finder with LCD Display

FOLAI 4-in-1 Metal AC Stud Detector

Product Code: HB-2612

Brand: Folai

Warranty: 7 days checking warranty

Availability: In Stock

Rs. 4,199

You save Rs. 1,800 (30% Off)

Product Description

Wide detection range - The maximal detection range of metal parts 3-inch AC wire 2-inch stud parts 1 5-Inch Easy to find the stud centre and Edges accurately Locates metal pipes live wire stud wooden frames rebar and joists which hidden behind walls floors and ceilings
Centre finding - AC wire warning flags will show on the LCD whenever live Wires was monitoring in three detecting modes Show column will elevating as wood stud finder approach item's centre and the highest column site is the centre of Studs Beep sound will remind you when you find the target
Calibration - Before detection please keep the scan button pressed for 1-2 sec and it will get calibrated Beep sound will remind you when job done You may need to recalibrate your device if the button was released accidentally at the beginning or you think it need to do so during the process
Excellent backlit screen - Features with LCD backlight providing a clear look even in low light conditions which indicates detection mode centre pointing low battery indication Audio indication with beep sound for reminding


In this mode detect live, unshielded AC wires, electrical wires up to 2 inches (51 mm) deep. For Safety, in all modes, this wall scanner always detect and indicate the Live AC Wire. Note: Wire Warning Detection works in both StudScan / DeepScan / MetalScan Modes. The Wire Warning Detection Icon will flash when live, unshielded wires are detected.	Use this mode to locate and avoid hazards such as pipes behind walls. Metal Scan mode detects non-ferrous metal such as copper pipe up to 1½ inches (38 mm) deep, and ferrous metal such as rebar, up to 2.36 inches (60 mm) deep. You can differentiate between metal and wood studs through this mode. First, find the stud in Stud Scan mode. Then, switch to Metal Scan mode, the tool alerts in a pattern as it detects the mental drywall screws in the wood for wooden studs.	We suggest you to use Stud Mode first to find the edges of wood and metal studs up to 3/4 inches (19mm) deep. If Stud Scan mode shows irregular readings or the Signal Strength indicator is weak, the studs might be behind more than ¾ inches (19 mm) of drywall.then switch to Deep Scan mode. This doubles the scanning depth to 1½ inches (38 mm) deep and allows for increased accuracy on deeper targets.


The stud finder can be calibrated anywhere on the wall. It automatically recalibrates, when needed, to successfully find the center of studs in one step. Place the unit flat on the wall, press and hold the scan button to start calibration, the decreasing bars will disappear and buzzer will beep one time and the calibration is completed	Slowly slide tool across the wall. A bottom pointed arrow and EDGE indication will illuminate, indicating location of the stud edge.	Continue sliding the tool. When the center of a stud is located, the full bars on the Signal Strength Indicator, the pointed arrow on the top of the bars, the CENTER indication will all show and the buzzer will sound.