Before use, take out module from the sillicone strap and then remove the battery insulator tab slowly. The module will start up automatically. No need to screw or open the battery compartment lid. Do remove the plastic protection on the lens.
To replace the batteries, open the battery compartment lid by loosening the screws using a screwdriver and pull the lid open. Insert 2pieces of AG-10(LR1130, DC 1.5V) batteries in correct polarities and position. Close the battery compartment lid and lock it with the screws.
Two buttons to access key functions:
Settings button: to enter the setting interface, push and hold the button for approximately 2 seconds. Once entered the setting interface, short push button to switch to modes corresponding to explained manual topics.
M button: short press to select preferred mode. Once entered the setting interface, short push button to adjust the item value. Push and hold the button approximately for 2 seconds to enter the fast transfer settings.
To get to time mode: long press settings button to get into time setting interface, single press settings button to switch category setting Hour-Min-Quit.
In settings interface, press M button to adjust the setting value(can only be increased), long press M button for about 2 seconds to enter the fast transfer settings. In setting interface, press settings button to quit or it will auto quit after 15 seconds.
Step Counter Mode:
After 7 seconds, step counter shows how many steps made before and will keep counting in a continuous movement. Step count data is updated in real time motion process.After step count reaches the maximum value of 999999, it will auto reset to 0. Long press M button for 2 seconds to reset 0 from current pace.
Important: While you reset the step counter, remember to reset the KM counter if necessary.
In step counter mode, long press settings button for 2 seconds to turn on or off the step counter function. When it is off, footstep icon disappears. When it is on, footstep icon appears on both step and time mode. When you use the step counter for the first time, the step counter is preset on. Turn off step counter mode when not in use to prolong battery life.
In this interface, long press settings button for 2 seconds to enter personal foot step distance setting interface. The foot step distance is preset at the value of 60cm. Personal foot step distances can be set from minimum 20cm to maximum 200cm. Measure your foot step distance in cm and set this as standard value. Press M button to adjust the correct value(each press will add 5 cm). In the setting interface, press settings button to quit. It will auto quit the setting after 15 seconds.
The step counter can be turned off manually. Preset is "on" after first activation. The step counter will start counting with each regular movement. When there is no movement after 1 minute, it will go into power safe mode. When the step counter is on power safe mode, a movement or press on any function button can activate the counter.
Press any button to activate the backlight. This will last 5 seconds for each press.
Fit Band Specifications:
Strap length: 220mm with adjustable holes
Strap thickness: 2mm
Battery: 2 x AG10/LR1130, DC 1.5V (batteries included)
DC 3.0V operation